CHIRTS FAQ

Intro

Thermal IR satellites image the earth constantly and the data are spatially and temporally aggregated, and released as "B1" worldwide IR temperature data at 0, 3, 6, 9, 12, 15, 18, 21 hours. These satellites sense brightness temperature (Tb) from whatever surfaces are in the pixel. Land in Africa will measure on the order of 280-330 K. If there is a cloud dominating the pixel then the cloud top temperature will be reported, on the order of 220K. Mixtures of clouds and land will result in a mixed reported temperature. While cloudy days are generally cooler than sunny days, clouds can be ephemeral. If a high cloud happens to influence the temperature of a pixel on a warm day, the day was still warm, but the data at that hour do not reflect that. So we

• composite the data by taking the maximum temperature within a 5x5 pixel region at each hour, hoping to remove spotty, small clouds
• if clouds remain, fill in cloudy "heat of the day" temperatures by determining what hour of the day was warmest with respect to the long term average for that pixel for that hour for that month, and adding that anomaly to the average high t. The idea here is that if it is a warm day with clouds during the heat of the day, but it is clear and relatively warm at some other part of the day, we use the anomaly from the clear values, added to the average high T for that month, to estimate a warm IRTmax.

Then we aggregate daily Tmax to get monthly Tmax, and compare the monthly Tmax from 1980-2015 to determine if, for example December 2015 was anomalously warmer than average. On to the details:

Algorithm

Just before we operationalized the IRTmax process, Seth was working in the Western US. There he noticed some years where the geo-registration could be off by quite a bit. Most noticeably with B1V1, but B1V2 data still occasionally had some variability in pixel location on the order of a few pixels. This is an issue for land areas next to water bodies for instance, or in areas of high topographic relief. We decided to avoid years, 1980, 1981, 1983, 1989, 1990, 1991, 1992, 1993, 1994 and 1995 for calculating the climatologies.

There are 25 good years left between 1982 and 2014.

The attached figure shows the various Geostationary sensors in use over the equator. The problem area for the US SW coincides with the GOES-7 period when there was only a single GOES for the US, so it had to cover both coasts. How to upload a figure?????????

This should have no bearing on Africa which has consistent satellite coverage, just wanted you to know why we selected these 25 years to make a climatology.

Start by making climatologies of expected brightness temperature for each pixel for each month, 8 times a day.

at each pixel, get all of the data over a calendar month, Eight times a day, using a 5x5 array centered on the pixel over 25 good years.

The first cut is to exclude any data points colder than 180 K or warmer than 340 K, this is just bad data.

Look at the histogram of all data points (binned every 3 degrees to avoid spurious maxima). The goal is figure out a mathematical way to trim the high and low outliers so that we are identifying actual anomalies from actual data rather than identifying cloudiness or misregistration or sensor calibration errors, etc. A histogram of all of the temperatures for a given pixel for a given month for a given hour will have a really long tail on the low end, and then a near gaussian distribution of good temperatures at the high end (cloud tops are colder than land). the low end is all of the solidly cloudy to partly cloudy data values. My first cut at this was to fit a gaussian to the entire distribution (which was dominated by the gaussian good values) and only keep values +/- 3 standard deviations from the mean. this works fine for africa as long as the amount of good values is >> the amount of cloudy values. for the western US, especially in winter, the overall distributions become distinctly non-gaussian, because there are so many cloudy data points. The second cut at this seeks to isolate the gaussian part of the distribution by finding the upper threshold (SD +3) and center point of the gaussian part (mean of the histogram) and then calculating the lower threshold (SD -3) assuming a symmetric distribution as (center - (thresh High - center)).

• we find the center by looking for the first local maxima when you start looking from the right side of the distribution. we do this because there can be bimodal distributions with the lower temperature peak being the erroneous one.

• to find the +3 S.D. upper threshold i calculate the 99th percentile of the entire distribution. There are some tricks here. you have to trim erroneous high values before calculating the 99th or else you will have a really high thresh H. I isolate the true end of the histogram by looking for bins having >10 counts in them (4 in a row) then 2 bins with counts of zero. in the cloudy tail there can be bins with values then no values, then values again, so if there are multiple instances of the xxxxoo pattern I take the higher instance. This works fine for most of the world. When Pete ran the code on the world from 70N to 70S it broke down in Siberia, Greenland, Antarctica. The fix is: if no xxxxoo then allow xxxxo. if not that, allow xxxxoo where x just has to be >0 rather than >10.

so we get a symmetric, gaussian like distribution of good Temperature values. getting the clouds out is incredibly important, obviously, and this works pretty well.

For each 3 hour period for each month we are left with a 4 dimensional array: 31 days x 25 years x 5 x 5

• take the maximum over the 5x5 neighborhoods, then the median over 25 years, then the median over all days in the month. This results in 8 maps (at 00, 03, 06, 09, 12 ,15, 18 and 21 hours) representing the 25 year average Temperatures, for each month (clim)

• for each pixel, calculate the maximum of the 8 clim maps, maxclim. the timing of the heat of the day depends on longitude.

• Now we go back to each day. for each of the 8 obs/day take an anomaly, Tb - clim(h)

• take the maximum of the 8 anomalies over the day, maxanom

• add these two together to get IRTmax for the day: IRTmax = maxclim + maxanom.

• for each month, daily IRTmax are averaged, and then we calculate the average over all years monthly IRTmax

• we subtract the overall avg monthly Tmax from each of the monthly Tmax for 1980 to 2015 to determine how a given month within a given year differs from the long term average.

These are hot off the press. No one has taken a look at these yet.... Have fun.

Fixes to make

one of the first steps in the process involves generating a histogram, per-pixel, of all of the Tb values through time. then we identify erroneous high values that would lead to a higher than correct upper threshold. the first way we did this was to locate the end of the real histogram by finding 4 good values in a row followed by two zeroes for the bins. this breaks down in Siberia/Greenland/Antarctica and if the xxxxoo search string isn't found the histogram isn't modified. I added 2 if statements to clarify things. if no xxxx00 then allow xxxxo. if not that, allow xxxxoo where x just has to be >0 rather than >10.

where code resides in Linux

Hi Seth,

My idl code for IRTmax lives here,

     /home/source/pete/IRT/seth-tmax

The month cubes by hour live here,

     /home/sandbox3/B1-GridSat/tifs/monthcubes/

IRTmax daily GeoTiffs, (1/2 Tb)

      /home/sandbox3/B1-GridSat/tifs/adjTmax.daily

IRTmax monthly Geotiffs,

      /home/IRT/Tmax/monthly

with subdirs,

                 /africa
                 /anom

various IRTmax pngs, (stdev, counts, more to come.....)

      /home/IRT/pngs/monthlyIRTmax

There you have it.

Take care,

-pete